- -₹21.00
Ferric Chloride PCB Etching Powder (50 gms)
This PCB etchant (Ferric Chloride) is perfect for etching DIY PCBs at home. Just mix it with warm water and start etching your PCB. Best part is that, the solution can be stored and used multiple times! Our Ferric Chloride etchant comes in a neat air tight box and contains 50 gms of Ferric Chloride! We have also carefully selected the best quality etchant for faster etching and long life!
This PCB etchant (Ferric Chloride) is perfect for etching DIY PCBs at home. Just mix it with warm water and start etching your PCB. Best part is that, the solution can be stored and used multiple times! Our Ferric Chloride etchant comes in a neat air tight box and contains 50 gms of Ferric Chloride! We have also carefully selected the best quality etchant for faster etching and long life!
Note: When mixed with water, Ferric Chloride forms a strong corrosive solution that corrodes and stains anything that it comes in contact with it. It is harmful to the skin and eyes. Hence, it should be used with the highest level of carefulness and with all precautionary measures taken. We are not responsible for any harm or injuries it may cause.
16 other products in the category
- New
Arduino Uno R3 with Cable
Arduino Uno R3 with Cable
- Micro-controller : ATmega328. ...
10K Potentiometer - 3 Pin...
10K Potentiometer - 3 Pin 15mm Rotary Shaft (Pack of 4)
- New
Original Arduino Uno Rev3
Original Arduino Uno Rev3
- Manufacturer: Arduino Officials ...
- Out-of-Stock
1×40 Berg Strip Male...
- Number of Pins: 40
- Pin Spacing(pitch): 2.54 mm
- Length of the Strip:...
10K Potentiometer - 3 Pin...
10K Potentiometer - 3 Pin 20mm Rotary Shaft (Pack of 4)
- New